You are reading a single comment by @SwissChap and its replies. Click here to read the full conversation.
  • Ooh that's a good idea! I've never used it before, but that should work quite well actually. Thanks! Any specific recommendations or should I just buy anything that says 'heat shrink tube' on Amazon?

    @Sumo

    Well ideally I'd like to avoid doing anything that can't be reversed, or that will impact the finish. If I knew I wanted to go fixed forever on that frame I'd just remove the mount entirely, but I'm pretty sure I'll be putting some gears on it in the future, so I'd like to keep the mount itself as it is.

  • Make sure its roughly the right size, as you'll be at the upper end of what's available on Amazon. If you measure the height and thickness of the mount you should be able to calculate it. I think the diameter should be bigger than (2*height+2*thickness) / 3.14. My guess is it's about 3cm high and half a cm thick, in that case you'd need a diameter of at least 22mm.

About

Avatar for SwissChap @SwissChap started