You are reading a single comment by @Tallboy and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Tallboy
A question for owners of older Cervelos: On the seatpost of a P3SL frame I bought, the bolt system on the seat clamp is rather annoying to use - one bolt is accessible from underneath, which is great. But the other one is a 'thumb bolt' that controls the saddle angle which, when you put the saddle on, is extremely difficult / annoying to operate, as you have no access from underneath (meaning I have to somehow jam my finger in to turn it). Am I missing something super obvious on this? Is there some kind of trick to make this easier? (It's very similar in design to a Fizik R1 seat post clamp, but that one has the 'dial' bolt mounted in a way that it is actually accessible even when the saddle is on the clamp)
My approach so far has been to dial it in roughly right before I put the saddle on, leaving the other bolt completely loose, and then to try to do the rest once the saddle is on - but you can't tighten it too much beforehand, otherwise it's impossible to get the saddle on.
Surely there must be something I'm missing? Grateful for any suggestions!