Electronic & Hydraulic Shifting (Di2, Ui2, customisations)

You are reading a single comment by @andyp and its replies. Click here to read the full conversation.

•

cjr

In terms of eTube wire length, is it best to go as short as possible, or is it easy to hide spare wire in the frame?

I'm thinking mainly of the battery wire and the one up the downtube. Both the ones that came with the groupset (1000mm and 1200mm) seem really long and I'm also adding the bluetooth module between the frame and bars so was going to swap them out for shorter ones.

•

andyp in reply to @cjr

It’s easy to coil excessive wire if required, especially with a zip tie or two to hold it in place. I used string to work out lengths, then ordered the closest size up.

•

cjr in reply to @andyp

Cheers. It came with set lengths but I think I will swap a few for shorter ones to avoid unnecessary coils. Are there any places you need more than you would expect?

About

Avatar for andyp @andyp started