You are reading a single comment by @Rodolfo and its replies. Click here to read the full conversation.
  • One reason I was hesitant was this: unicrown where the tubes are proud of the steerer column, not leaving a huge amount of space to drill. I didn’t fancy DIYing and potentially wrecking it. Argos will charge me what I could probably get a new fork for.

  • https://www.flickr.com/photos/124172836@N06/page4

    there are the pics of the fs thread. apparently that frame sold 5years ago. im effin getting old!

    the below picture shows the hole best. it is quite down low, to evade the tubes as is your predicament.
    ild drill it a bit up though.
    also, heed the good advice given by the rest of the hive mind


    1 Attachment

    • 14042410966_75b2913f4d_k.jpg
About

Avatar for Rodolfo @Rodolfo started