You are reading a single comment by @Jonny69 and its replies.
Click here to read the full conversation.
-
@AlexD this was what I was going to suggest and file one side of it to sit flush on the front of the fork.
I think I’d drill it in the material just below the unicrown, but stick a wheel in and measure where the caliper drop ends up first (in case it puts the caliper in the wrong place). If you have a few calipers knocking around on other bikes it might be worth eyeballing them in case one of them will work better. I happened to have a mega low drop Campag caliper that fitted my fork a lot better than my intended single pivot Shimano 105 was going to.
Jonny69
You would use one of these...
https://www.rockandrollbikes.com/weinmann-front-brake-curved-washers.html