You are reading a single comment by @tallsam and its replies.
Click here to read the full conversation.
-
Based on the ziptie jig shot I thought that dropout repair was going to end up much worse than it did
Melt-out jig, innit. Lost wax process.
-
Haha thanks mate. The cable ties were to hold the 10mm nut in the middle!
The Cannondale is a different project. The headtube on it was bent in after previous owner dropped it on the floor without a headset in. All fixed with a car body work hammer and ready to be built as a commuter for a friend :)
Jonny69
getoutofbed
@tallsam
Based on the ziptie jig shot I thought that dropout repair was going to end up much worse than it did. Well done.
Is that Canondale Saeco getting the same treatment? Is it Alu?