You are reading a single comment by @Thuekr and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Thuekr
Hulsroy
There is a 6mm deep groove along the flange on the face of the dropout. The contour tool path machining the flange sides went too deep. I just didn't spot it as I didn't run a simulation before machining. Basically a rushed job and my mate who assisted me (my first time using Fusion 360) didn't pick up on it either.