You are reading a single comment by @Hulsroy and its replies.
Click here to read the full conversation.
-
There is a 6mm deep groove along the flange on the face of the dropout. The contour tool path machining the flange sides went too deep. I just didn't spot it as I didn't run a simulation before machining. Basically a rushed job and my mate who assisted me (my first time using Fusion 360) didn't pick up on it either.
1 Attachment
-
Hulsroy
Thuekr
drøn
What went wrong?
apart from a notch in the slope on the LH cowl, I can't see it...