You are reading a single comment by @chiroshi and its replies.
Click here to read the full conversation.
-
Hmm, that's what I was worrying. This is frame #001, which I think was an 'advanced prototype' rather than final construction, and it doesn't quite fit 35mm tyres so something was lost in the clearance. I've just seen PDW have released a 'road plus' 35mm size which might fit better, but bike24 haven't got stock yet.
chiroshi-
I had some success on my 55cm model by rather than cutting, mildlybending the 45mm PDW guards to fit between the chainstays. I managed to get 30mm G-ones underneath.
I used some of the (really high quality) anti-rub tape on the inside of the seatstays too.
I agree with @Señor_Bear with the front mech update. Will save a lot of hassle.
-
I have a set of grey 30mm PDW in the shed. You are welcome to try them.
motoko
Aroogah
That looks tight. Which is strange because I have a 53 and have fitted 45mm PDWs without much hassle. Bit of tape on the seat stays to protect them, a longer alan nut to reach from the bridge to the guard and I had to trim the front guard stays. Have fitted 30mm G-Ones under the guards as well.