You are reading a single comment by @Howard and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@Howard
Question for the pros. This might be a bit it depends but I'll try anyway:
I want to re-dish an already built wheel 6mm to the NDS.
Assuming the wheel is as well built as can be, and that the re-dishing is done well, will re-dishing to this extent cause issues with spoke thread engagement?
My plan to do it would be to record the spoke tension across the build, then back off the tension on the DS a uniform amount, then tighten the NDS a uniform amount, trying to retain the original build tensions across the wheel. Is this the best way to go about it?