Workshop...in progress...

You are reading a single comment by @pdlouche and its replies. Click here to read the full conversation.

•

salad in reply to @pdlouche

Had this in my head last night when I couldn’t sleep. Made it on a whim this morning. Of course with a nice angled flap and better stitching etc, it could work. Pure seatbelt goodness.

This looks very nice (and very tough) !

Have to say I like the look of the non-angled version a lot better!

•

pdlouche in reply to @salad
Probably I’ll go with square edge. You don’t wanna see the handful of attempts on the floor from seatbelt fraying when cut at an angle...

3 Attachments

•

MisterMikkel in reply to @pdlouche

Is that seatbelt used as edgebinding on the flap too?
Looks like it'd fit right in on the utility belt.

About

Avatar for pdlouche @pdlouche started