You are reading a single comment by @Olly398 and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Olly398
So to cement my lack of knowledge in this department..
Can a belt in a car for a certain position and pulleys look very different yet carry out the same quality job? I realize the belt and pulley dont mech like a chain and cog so they may perhaps be perfectly fine even tho they look very different?
The fine tooth one is the one i cut out from the car.
The longer less pointy belt is the one i think was originally in the car in the same possition as it more or less matches in length if i count the bit still stuck in the pulley..
would both these 2 belt types work fine on the pulleys seen below ? Was originally fitted to the pulley furthest to the right i imagine..
Thank you!