Home DIY

You are reading a single comment by @Polygon and its replies. Click here to read the full conversation.

•

NotThamesWater in reply to @Polygon

Scutch chisel, scraper & wire brush.

Needle gun to getbthe last bits off, if you want to spend money, and if the bricks aren't too soft.

Or just lime render over it.

•

Polygon in reply to @NotThamesWater

It's pretty damn loose, so hopefully shouldn't put up to much of a fight. Will go at it tomorrow.

•

NotThamesWater in reply to @Polygon

I'd suggest a proper respirator mask. Lime plaster dust is not as bad as gypsum, and using a lump hammer not as bad as an SDS chisel, but it's still no fun to breath that stuff.

About

Avatar for Polygon @Polygon started