You are reading a single comment by @dicki and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@dicki
i'll whip off the free hub body and check inside the hub
no bearings were changed, it was a dismantle clean then a put back together again, everything seemed fine in there, no bearings were touched
i used a bearing grease, a similar looking amount to that which i found from the factory set up when i dismantled, i've done a few before and always just stuck a couple of blobs in the gaps before the pawls and springs went back in, and a bit on the teeth the pawls engage with