You are reading a single comment by @Howard and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Howard
hippy
Yes I could make one myself, no I'm not going to.
So, is there a better version than this I should consider for pressing BB30 bearings in?
http://www.chainreactioncycles.com/x-tools-press-fit-bottom-bracket-installer/rp-prod155423
Actually, I may have the BB30 remover from Park (https://www.evanscycles.com/park-bb30-bearing-tool-set-EV185248) so perhaps only need the threaded rod bit, but don't want to pay £50 for Park's headset installer.
Any other options I can get delivered early next week?