You are reading a single comment by @NotThamesWater and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
NotThamesWater
Cutting sheets of mdf, assembling stuff, just general table top to work off.
My plan is to screw sheet of something down to two 2x4's and slot them in to my sawhorses. My current setup is a random piece of mdf resting on them but its not fixed and wobbly and would rather something a bit more sturdy.
I wouldn't leave it out in the rain but it would be stored in the garage which can get humid so perhaps OSB not a good choice? I could drive over to acton to get some exterior ply but its a pretty long round trip. And marine ply is very expensive.