You are reading a single comment by @Thuekr and its replies.
Click here to read the full conversation.
-
Upper/lower limit screws set properly?
-
Check connections, then check connections...then re-check connections. Also asking the obvious. battery charged?
Loose wires was one of the most common things I encountered. Either bar tape too tight, or too loose. -
Have you tried turning it off and turning it back on again?
-
I have no knowledge in these things.
Check battery charges, check the status on the junction box under stem, and if nothing, get it diagnostic.
TooTallTim
Chak
gbj_tester
edscoble
@Thuekr
I have no knowledge in these things, but suddenly the bike will not shift to bigger cogs on the cassette - stops in the middle of the cassette, when I'm trying to shift to bigger cogs.
Dura Ace di2