Electronic & Hydraulic Shifting (Di2, Ui2, customisations)

nice angle to hide spacers

But not the tape job

I'm not embarrassed about my spacers...I'm getting on a bit now!

1 Attachment

In the Urban?

My new (to me) winter bike runs a 105 disc brake setup. What's the cheapest way to go electronic? Basically, sti's, mechs and wires/battery etc.

And where's cheapest?

Just pulling your legs when you said “wild”.

It shift well, hood are comfty, haven’t really ridden it enough, still rather go for Shimano or SRAM.

Interesting. it’s for show bike, So I won’t be paying for it.... just wasnt sure if WE is going to be as bad as I think it’s going to be.... not that I have any basis for this opinion TBH!

that's a bit of a fancy bike, what's the weight out of interest ?

thanks (put together on a budget) not weighed it but feels lighter than my Scott CR1 which was 15.5lb

budget of course , what else ! this is less thant 7kg ?

Less thank £2.5k for full build. Frame is 870g, wheels 1500g and etap is relatively light so I think so

thanks, a good shopping list that was, well done

Snap

(I'm not ashamed of my spacer stack either)

1 Attachment

nice, your location looks a tad nicer than mine as well!

https://www.bikeradar.com/road/news/article/shimano-di2-wireless-51967/

What's the best price for the R8070 groupset? Evans looks the best at £1330, anyone seen it at a better price from reputable seller.

Without spending all afternoon googling, does anybody know where the cheapest place selling Etap Shifting kit is currently? (shifters/mechs/batteries/charger)

Is £1100 including VAT at trade from Zyro.... am i likely to find cheaper anywhere else?

https://www.bike-components.de/en/SRAM/Red-eTap-Road-Shifting-Groupset-p47128/
Maybe not the cheapest out there... but its cheaper than Zyro.

Thanks!!

Check out Starbike in Germany as well.

I just got my full eTap HRD from there.

Does anyone have any suggestions how to mount my Di2 junction box / ideally underneath a wahoo mount. I haven’t googled properly, but I want something like the Tune Porteur, but I have a dead stem. And no I cannot use the superzero clip :(

Any suggestions. Don’t want to use the rubber band 🤦🏻‍♂️

I used small amount of Sugru to stick the junction, excluding the clip bit for a lower profile, to the underside of my stem. Did it a fortnight ago and seems rock solid.

Previously had the junction mounted to the underside of the puck end of a standard Garmin mount -unscrewed the puck then ran two very small zip ties through two holes, secured those to the junction, then screwed the puck back on

Awesome thanks for the tip.

Epoxy the junction box clip onto the underside of the stem.

1 Attachment

👊🏼👊🏼