Dynamo Lights

You are reading a single comment by @hippy and its replies. Click here to read the full conversation.

•

Fforiwr in reply to @hippy

99.9% certain it's wired up correctly, but obviously doubting myself because it's not working. I've had to lengthen the cable overall so have added another section which adds another point for faults to creep in too.

Will check and check again. Sigh.

•

hippy in reply to @Fforiwr

Test it without any of the joins. Can you run another length of cable loosely from the first exit point of the front light? So you can quickly test it both ways around. If it lights up at all then one of your joins is arse about or shorting out.

•

Fforiwr in reply to @hippy

Found it. Was in the join closest to front light that had never been changed even when swapping bikes, I trusted the heat shrink but must have got pulled when fitting it to new bike. I had assumed the fault was in the new connections.

Ah well, 3rd time lucky. Cheers

About

Avatar for hippy @hippy started