You are reading a single comment by @russmeyer and its replies. Click here to read the full conversation.
  • Trying to figure out where to put the mudguard eyelets. I realise many of you probably think I shouldn't do this but it's wet here and I'm old and uncool and don't care 😉

    Nevertheless, it obviously looks crap and the dropouts are pretty distinctive on these frames so would be nice to screw them up as little as possible.


    3 Attachments

    • IMG_20180311_223514~2.jpg
    • IMG_20180311_223613~2.jpg
    • IMG_20180311_223536~2.jpg
  • put them on the inside side of chain stays.

  • My choice would be halfway between your first and second positions, but use a round file to file halfway into the dropout so it's semi sunk in. Braze in a slight fillet on each side and it'll look like it was there from the factory.

About

Avatar for russmeyer @russmeyer started