You are reading a single comment by @π
π
π
£π
£ and its replies.
Click here to read the full conversation.
-
Perfect β if everyone simply replies to confirm with only their spec I can upload to the sheet.
π
π
π
£π
£-
Dope
-
1 1/8, clamp 25.4, -6 degrees, length 120, height 55
Thanks γ
-
It is only possible to have clamp on front side on stems where there is at least 25mm "spacer stack" under stem.
with this info I'd like to slightly alter measurements;
1 1/8, clamp 25.4, -6 degrees, length 120, height 65
TIG, black powdercoat, clamp on front sideif @Batt could add to G sheet please, @Hulsroy dunno if you need the later details yet, but rather get it all posted so u can start planning
-
D 1 1/8" / ΓΈ31.8 / +-0 / L 80 / H 75
Tig
Unpainted
Clamp on frontThanks :)
Hulsroy
packet
Po
Thanks @Batt for the google sheet. Let's go with that. Would it make sense to only have you as admin? Then I'll give you good discount on the stem.