Can the 3D print take that much pressure?
Don't see why not. The faceplate stem bolts are only done up to 4 or 5Nm, which would result in very little compressive load on the mount. But I'd assume that the mount above is intended merely as a prototype rather than a production-ready product.
This one cant, but the ABS one that will follow should be fine.
@pifko started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Can the 3D print take that much pressure?