You are reading a single comment by @dangeek and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
dangeek
stevo_com
For right angle cuts; cut, flip the piece, cut again. You could do the same for angled cuts if you're careful. And if you are only slightly shy on the right angle cuts, just tilt the board up towards the end of the cut. I didn't need to use the slide cutting 6" x 2" joists.