You are reading a single comment by @Heldring and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Heldring
larsenroad
So the frame will hopefully take up to 650b 3.0 and 29" 2.3. 68,5 degree head angle and 74 seat angle. I wanted to keep the chainstays as short as possible without bending the seat tube because... I don't like bent seat tubes. So they ended up at being 433mm. A nice and short 44mm headtube and room for a rowdy 120mm Pike fork. I went for a T47 BB so I can try to route the dropper cable through it and exit at the top of the down tube. On the non-drive side the rear derailleur and brake cable will enter at the top of the DT, exit before the BB and back in the chainstays. Should look quite neat and clean. Extra bottle mounts under the down tube.
Oh, and it's titanium.
We're still figuring out the logotype, but I'm pretty much set for a color split, leaving the rear raw brushed Ti.
Here's a couple of sketches.