You are reading a single comment by @floatingcyclist and its replies.
Click here to read the full conversation.
-
Used the Tekro R559. Just about reach. Worst thing about them is I know all the hardware will go rusty. Might look in to replacing that with ti/stainless.
Yeah the hydraulic guides, used gorilla double-sided tape as insurance. Tried the di2 guide thing but I think the curve on the small diameter steel tubes was too much for them.
I'll probably try a front rack at some point, just holding out for a good price on an m18. Not sure what to do about a decaleur, might get something fabricated.
Polygon
@floatingcyclist
Looks great. Are you going to add a front rack as per your original photoshop? What non-mind blowing brakes did you use in the end?
Are they hydraulic brake cable guides you used for the dynamo wiring on the fork leg? That's what I used on my Soma GR. Kind of works okay even though they don't hold the coaxial tight.