Isen workshop: adventures in batch production (or not...)

You are reading a single comment by @deleted and its replies. Click here to read the full conversation.

•

Scilly.Suffolk

Anyone else used Shimano brakes with the Easy Hose Joint System? It doesn't fit through the down tube, so I suppose the end needs to be cut off. Did you reuse the insert?

And can anyone suggest something to blank the Di2 holes in the frame off with?

•

deleted in reply to @Scilly.Suffolk

Snip the end off, don't wave it around too much and you'll still be fine.

Normal di2 grommet with a blob of grease in the back side will be water tight ;)

•

Scilly.Suffolk in reply to @deleted

Snip the end off...

And reuse or replace the insert?

Normal di2 grommet...

These?

I was hoping to find some actual blanks: a cable grommet without a cable looks like a bit of an afterthought. It would be better if the down tube port was left blank, like the seat tube and chain stay ports.

About

@deleted started