You are reading a single comment by @M_V and its replies.
Click here to read the full conversation.
-
When you adjust it so you can get the smallest cog is the shifting better over the 3 or 4 cogs at that end of the block than the 3 or 4 at the other end?
Vice versa, if you adjust it to get the biggest is the shifting better at that end?
If so, the hanger is bent.
M_V-
It is currently set up so it can shift into the smallest cog
In the stand, as you are coming down the gears (to the smallest) they all click through, until you get to the smallest where it takes two clicks to get in. Feels quite smooth until that point.
When you are riding though it just feels pretty rough and doesnt change gear, seemingly at any point in the block, will check on my ride home if its towards any particular end of the block.
apc
I am struggling to get my rear derailleur to shift to both the smallest cog and the largest
If I lower the cable tension then I can get it into the smallest cog, however, then there isnt enough tension to get it into the largest.
The moment I increase the tension the derailleur moves left slightly and its then impossible to get the chain onto the smallest cog but it will then at least go into the biggest cog
Any ideas??
(shimano ultegra 6800)