You are reading a single comment by @Markgee and its replies.
Click here to read the full conversation.
-
Should be pretty straight forward TBH. Seen much older frames go from 120-130 (that's stronging it imho but it can be done).
Remember that the stays will bow from the bridges as the bending will start below. Sometimes this can look completely wank. The pro way is to take the bridges out and cut new ones to fit the wider spacing.
I'm looking to get my 80s Daccorddi Columbus SLX frame cold set at the rear from 126mm to 130mm.
The rear triangle is chromed.
Is there any risk that the bending process will fuck the chrome, making it flake or any other bad side effect?