I am a frame builder AMA

You are reading a single comment by @deleted and its replies. Click here to read the full conversation.

•

mcmyk

If I was going to have a go at building a lugged frame with a kit from ceeway, can I silver solder the lugs on with MAPP gas and then tig the rear dropouts in?

•

deleted in reply to @mcmyk

Drop outs: as long as they aren't carbon that's no issue.
MAPP: Yes, but it's boring and slow. Oxy propane is not much more expensive and way betterer

•

mcmyk in reply to @deleted

Ace thanks.
When you say oxy propane, i have seen the small setups you can get for roofing etc, like this?
I know the small bottles aren't so cost effective but this is somewhat of an experiment

About

@deleted started