You are reading a single comment by @Vince and its replies.
Click here to read the full conversation.
-
The issue is that all the teeth of the cup are gone.
I have a fine thread bolt and a large washer which I use to secure the BB tool to the BB cup.
Then use a long metal tube for leverage.
3 Attachments
-
Vince
-
That's not a bad idea. Does the bolt need to be so long? Would a crank bolt not work OK? I did try that technique, but the threaded hole in the taper was full of mud/rust so I gave up...
-
No it was something else. Perhaps it wasn't you.
It used penny washers: maybe you need two nuts, lock one of against the other and then turn the locked nut to rotate the cup?
Of course the problem being that you need to remove the cartridge first...
-
Do you have the other side out?
-
Is that long metal tube a vacuum cleaner tube? I knackered one doing that.
fizzy.bleach
Scilly.Suffolk
Jaap
chez_jay
Something something... a large nut & bolt ...something something
@Vince