You are reading a single comment by @PhilDAS and its replies.
Click here to read the full conversation.
-
If you are using the 109mm axle then you need the BB30 sisl2 non drive and drive side spacer.
If you have the old 104mm axle then you don’t need them.
-
Have you seen this thread? >>> https://www.lfgss.com/conversations/263140/#comment14034894
I was looking into Hollowgram axle widths for my fatbike last summer, might be some useful info in there...
Or maybe the useful stuff is in one of my scruffy notebooks next to my toolbox :-/
I got my spindle and spacers from Qwerty Cycles.
Howard
Emyr
@PhilDAS
What do I need to fit these SI cranks on my bb30 caad7?
I’ve got the cranks, bearing shields, a few small shims and wavey washer.
Getting super confused reading tech docs but I keep seeing a big fat spacer on the non drive side, 5 or 10mm or something. Where can I find these?
1 Attachment