You are reading a single comment by @gbj_tester and its replies.
Click here to read the full conversation.
-
measure to outside of flange or centre? I would think it's centre, but then that's not where the spokes come out
Do the maths and see how much difference it makes (hint: it's not a lot). If you use the centre, the error on the outbound spokes will be about -0.1mm and the error on the inbound ones will be about +0.1mm
gbj_tester
measuring hubs: measure to outside of flange or centre? I would think it's centre, but then that's not where the spokes come out. Come to think of it that PDF probably says but I've not read it yet.
Also on this Shimano chart, 'offset' means the offset of the centre of the flanges from the centre of the hub right?