You are reading a single comment by @PhilDAS and its replies.
Click here to read the full conversation.
-
How was it done originally?
di2. It had 2 cable stops out of the factory but the shop drilled one out to fit di2 for Dammit.
steerer mounted cable guides
I can't picture how this would work since the cable needs to go inside the frame where there's now just a hole instead of a stop
PhilDAS-
just go 1x? All you need is a narrow wide chainring ..
-
Ignore me, I've got the wrong end of the stick.
Could you run a full length outer through the frame into this?
amey
Scilly.Suffolk
How was it done originally?
Perhaps with this: it looks like it has a stop on the end.
Otherwise, I've seen steerer mounted cable guides, but can't find an example. Basically a large washer (that fits under the bearing) with guides on either side. You should be able to bodge a stop/adjuster in there, as I recall the guide is just a tab that's been rolled into a tube.