Custom Chinese Ti - Hydro Disc by Waltly

You are reading a single comment by @ourmanflint and its replies. Click here to read the full conversation.

•

Saffronspokes in reply to @GoatandTricycle

You were correct

Mount issue is rear and cable issue is front!

Only slight annoyance is how close the disc rotor sits to the front fork, it's super close. Although that is no fault of Waltly!

•

ourmanflint in reply to @Saffronspokes

The clearance on my rose front disk is only 2-3mm, rear is about 5mm

•

Saffronspokes in reply to @ourmanflint

It's around 1mm it's so close that If I use the centrelock to 6 bolt adapter on the hunt wheels it doesn't fit and rubs. I wondered if there was anyway to put spacers on the thru axle as it only gets close when fully closed and tight.

About

@ourmanflint started