A Straggler for all occasions (and 2018 pivot mach 6 carbon)

I cant seem to upload more than one photo, but here are some of the mudguard mounting solutions. Firstly trimmed the bottom of the rear mudguard, to fit between the chainstays.folded the ends over to keep the shape fair. Used a bit of 8mm stainless tube, cut to the appropriate length, with a washer either end, and a longer bolt, to attach it to the frame.
Cut and bent two brackets, obviously measured to be the right length for front and rear, respectively. Drilled them and drilled the corresponding hole in the mudguard. Mounted them on little rubber pads. Doubt it's going to make much difference, but it might help damp some vibration.
Used an old pair of rigger boots to make some mud flaps. Had a convenient bit of rubber on the heel, which helps hold a good shape.