You are reading a single comment by @upstart and its replies.
Click here to read the full conversation.
-
You can adjust the lever throw a bit. Check the little grub screw up in the hood between brake lever and gear paddle, labelled 'reach-adjust pushrod' on page 16 of this. Tighten it up to push the lever away from the bars. Mine is always coming loose and I find the levers at the bars every so often.
𝔒𝕨𝖑𝘡
@upstart
Finally went hydro at the weekend. Cable trimming and internal routing meant a bleed was needed afterwards so got round to that last night.
Still seems like quite a bit of lever throw though, can anybody confirm if the pic looks ok?
I got a lot of bubbles out and the levers could touch the bars pre-bleed.
1 Attachment