You are reading a single comment by @yoshy and its replies.
Click here to read the full conversation.
yoshy-
Ah right, I put the guard in, marked it up and with a fresh Stanley knife carved out an arc on either side - little by little I kept placing the guard back between the fork and stopped when it just sat nicely without being squeezed. I then finished off the arcs with a fine file. Because the arcs are only the width of the fork blades you can't really see, I think I would struggle to photograph it without removing the guard.
TM
No picture but I drilled straight through the chainstay bridge and put the bolt through with washer and nut on the back. Can get a photo if you want but it's nothing fancyz