I am a frame builder AMA

You are reading a single comment by @Brommers and its replies. Click here to read the full conversation.

•

dbr

Can I tig tubes onto this cast bridge?

•

Brommers in reply to @dbr

Don't see why not. It'd be like any other butt joint. Won't it look a bit fugly though? It'd rather ruin the clean smooth lines of the wishbone, even with most excellent welds.

•

dbr in reply to @Brommers

Could grind a vee and fill it up with weld, grind back so it’s smooth... I’m more concerned about TIGing cast parts though. Seem to remember reading somewhere that they’ve got lots of impurities so the weld is wack.

About

Avatar for Brommers @Brommers started