Wheelbuilding / Wheel Building / Wheel build help

You are reading a single comment by @gbj_tester and its replies. Click here to read the full conversation.

•

Turkish in reply to @TvH

Id rather round 273.5 down to 272 than up to 274. Probably not much in it though

•

gbj_tester in reply to @Turkish

Id rather round 273.5 down to 272 than up to 274

Depends whether EDD accounts for spoke stretch. If it doesn't, I'd round down, if it has already accounted for stretch then 274 instead of 273.5 will be fine.

•

TvH in reply to @gbj_tester

Depends whether EDD accounts for spoke stretch

How do I tell? Results were the same within 0.1mm in the DT Calculator, does that?

About

Avatar for gbj_tester @gbj_tester started