"A bad workman...": the tool-chat thread.

You are reading a single comment by @fizzy.bleach and its replies. Click here to read the full conversation.

•

fizzy.bleach

Here's an odd one. My cassette tool has a little stick in the middle to centre it in the hollow axle. However, I've come to tighten a cassette up and the axle is too narrow for the stick. Whut?

They're Hope hubs, and a QR skewer goes in OK. Really effing annoying.

•

M_V in reply to @fizzy.bleach

Never seen the point of those ones over their non stick adorned brethren.

Have both at work, never reach for the sticky one.
•

psg1ben in reply to @fizzy.bleach

Yup, also doesn't like hubs with cassettes and solid axles. I don't really see the point, I've never had a cassette locking tool sit at a funny angle.

About

Avatar for fizzy.bleach @fizzy.bleach started