NJS (No Joint Safety) Carbon

You are reading a single comment by @Clesmon and its replies. Click here to read the full conversation.

•

drøn

If it was me, I’d cut the tubes a couple of cm from the lug and glue carbon tubes inside the stumps.
Carbon tube OD needs to match steel tube ID at the butted ends so maybe difficult to find the perfect fit.

•

Clesmon in reply to @drøn

Ahh I did think about this. And also thought about it in reverse (buying Oversized carbon) and making the ID go over the OD of the steel lugs, but then I ordered the wrong size.

So I’m just going to dremel most of the luge off and mitre the tubes hopefully well

About

Avatar for Clesmon @Clesmon started