Rat Bikes! Pub Bikes Beaters! Frankenbikes!

You are reading a single comment by @hamrack and its replies. Click here to read the full conversation.

•

Tijs in reply to @hamrack

The steel of the stays isn't exactly hard so you won't flatten the shearing edge.

I dunno. When I used a dremel I couldn't really imagine doing the same with a cable cutter. But perhaps you're right!

•

hamrack in reply to @Tijs

I used a dremel a few times and found the cutters much faster. Maybe I'm using the wrong dremel tool but I did check over the cutters afterwards and couldn't see any damage.

TL;DR they both work

•

MisterMikkel in reply to @hamrack

SKS makes some really tough stays. I can't imagine anyone getting through those with a pair of cable cutters.

About

@hamrack started