You are reading a single comment by @PhilDAS and its replies.
Click here to read the full conversation.
-
Think I’d prefer the 102 or 104 aesthetically though.
Realistically, do you think it would be at all likely I could just braze a disc tab straight on myself, being a total novice. I’m fairly handy and I’ve done a bit of mig welding but never brazing. Wondering whether to just order the bits and give it a bash.
It’s on the rear of the frame and most of the braking is done on the front anyway, I have a disc fork made by someone else entirely more professional than I
PhilDAS
M_V
Art.100 is one along, one down from Art.101, nestled between 176 and 118, obviously! Not sure if they are 6.3 or 6.7mm - will measure tomorrow. If you're doing this for discs, will you be going for hydraulic or cable. If hydraulic you'll want something else, as you'll have to pass the tube with an end fitting through, or have an doofer that takes a little clip or cable tie (Art.200, fourth row, third in).