You are reading a single comment by @Brommers and its replies. Click here to read the full conversation.
  • Leaving it in place isn't an option.

    Especially now that its received the lump hammer and brass bar treatment.

    Sorry that's not helpful but you might be stuffed - epoxying stuff in to carbon is a really bad idea unless you want it in there for ever.

  • The brass bar is a nice close fit in the BB cup, and I've been lamping it from the reverse side, so the recess for the bearing is untouched. Still won't fit a 30mm axle though. I have a horrible feeling I'm going to end up having to cut and file the damned thing out.

  • I have a horrible feeling I'm going to end up having to cut and file the damned thing out.

    I guess caustic soda isn't going to be too nice to the crabonz...

    I can't imagine you are going to end up with a great surface on which the new BB is going to press in to if you cut it out?

    If it's not dead, I'd be looking for a 24mm crank and cursing the guy who thought gluing it in was a good idea

About

Avatar for Brommers @Brommers started