You are reading a single comment by @hippy and its replies.
Click here to read the full conversation.
-
If you find one can you post link? I presume I will need one to do the bearing swap. I'm sure I will end up bodging it with some other tool but it's nice having proper one.
hippy-
Will do. Existing bearings seem to be holding up OK with the new longer Ti spindles and fresh grease, but I reckon you could bodge it with tweezers or something. Can't be arsed to pull them apart to do it again quite yet although some occasional new mystery clicking noises when I'm out of the saddle might hasten the rebuild...
TurtleRecall
Anyone got a link to a good circlip tool for the little speedplay circlip? Got a proper shit £3 eBay one that's not doing the trick. The little prongs are too big and it's got those ends you can swap out and they're all floppy and shit.
PS - J&L ti spindles just turned up, they seem good. I've fitted them with the existing bearings but could do with replacing them when I can get the circlip out.