You are reading a single comment by @deleted and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@deleted
This is the rough idea for the seat tube notch fixture. I'm not going to be buying an anvil one or anything, I can't see the point for such a defined cut, and I can make one for a fraction of the cost. Something went wrong with the tube holder in the render, bolts have disappeared and a few faces are fucked but you get the idea. The phase guide rotates around the t slot to allow for different head angles, and can slide along the t slot to accommodate different length tubes. Angle will be set by rotating machine vice that it will be clamped to.
Will order bits tomorrow, but should be quick and easy. Dependent on cost may just make the long support from ss right angle, we shall see.
1 Attachment