Isen workshop: adventures in batch production (or not...)

You are reading a single comment by @deleted and its replies. Click here to read the full conversation.

•

Scilly.Suffolk

Thanks for the explanation.

Getting adequate penetration with those tight angles/thin walls is mad skillz.

And congratulations on the mill-hoard!

•

deleted in reply to @Scilly.Suffolk
It's taken a while to get to an acceptable standard, it would have been easier with the lower amp method, but coming from fillet brazing I really like the smooth transitions of higher amps..

1 Attachment

•

Scilly.Suffolk in reply to @deleted

the smooth transitions of higher amps

Splatter's not an issue with moar amps?

Or is that only MIG?

About

@deleted started