You are reading a single comment by @Scilly.Suffolk and its replies.
Click here to read the full conversation.
-
It's taken a while to get to an acceptable standard, it would have been easier with the lower amp method, but coming from fillet brazing I really like the smooth transitions of higher amps..
-
Penetration is much less of an issue with thin walls and tube mitres than blowing through is. It's pretty obvious if you haven't.
Framebuilders group is kicking off at the moment between ti builders over whether fusion passing is beneficial or detrimental. So little social skills so much argon used...
deleted
@Scilly.Suffolk
Thanks for the explanation.
Getting adequate penetration with those tight angles/thin walls is mad skillz.
And congratulations on the mill-hoard!