I did it the way they came out so that the ring on the top in this pic was facing the inside of the BB, and so the balls' faces were facing the inside of the locking cup
goes the other way around iirc, you want the bearings on the axle side so it can roll around the cone I think?
@ldphotoworks started
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
I did it the way they came out so that the ring on the top in this pic was facing the inside of the BB, and so the balls' faces were facing the inside of the locking cup