Headset Help!

Posted on
  • So im fitting my 1 & 1/8 headset and the dust cover/ top mount is not fitting flush, which is rideable but bugging me to hell. plus if i leave it like this the bearings wont last long.

    i think that the issue is that the compression ring that sits on the top bearing is too high but it wont physically go down any further. i think i need a lower profile compression ring. second opinion?

    these normally come integral to the headsets anyone know where i can find one?


    1 Attachment

    • Screenshot_20170609-202431.png
  • pic 2


    1 Attachment

    • 20170609_194205.jpg
  • Did you get to the bottom of the problem with this?

    Was the crown race set correctly? It all looks off-kilter

  • Post a reply
    • Bold
    • Italics
    • Link
    • Image
    • List
    • Quote
    • code
    • Preview
About

Headset Help!

Posted by Avatar for shane89 @shane89

Actions